The EMPI Reproduction 30/31-PICT replacement carburetor comes jetted with the following.
Jet - 120
Idle Jet - 50
has been many "Chinese Made" carburetors come into the market over
the last few years. We have tried and tested all of them. We are very confident
to offer this TOP QUALITY
30/31-PICT carburetor. All other of the no-name
brands from China have proven NOT to be well made. As with everything, you get
what you pay for.
How long should your 40 PLUS year old carburetor last? Your old original
carb. has simply worn out. Every time you push the throttle, the throttle shaft
wears against the carburetor body creating wear. After years of this, the wear
between the shaft and body allows air to slip through the gap entering the
engine. Your old carburetor has no way to adjust for this un-metered air,
throwing the idle fuel mixture so far out of adjustment that you will never be
able to get the car to idle properly once it has warmed up. The only answer?
You need to buy a 100% new carburetor. Even so-called rebuilt carbs do not
address this problem. We stock a complete selection of Brand new Carburetors.
For best results, we recommend that you DO NOT use a "009" mechanical advance distributor with the 30/31-PICT carburetor. The "009" Bosch mechanical advance distributor does not advance until the engine RPM's have increased, but the Stock (or near stock) Beetle/Ghia 1600cc engine with stock carburetor requires advance the instant the throttle peddle is pressed. With a "009", this results in a large flat spot (or hesitation) when you leave a stop sign. This is not a problem with the carburetor and CAN NOT fixed by adjusting the carburetor. For the very best results we recommend that you purchase a new Vacuum advance distributor at the same time you order you new carb. Click here to see part number VWC-043-905-205.
Special note about carburetors: (they are non returnable!) We sell only 100% brand-new carburetors manufactured by Cip1, Weber,Solex, Brosal,Empi and Euromax. Every carburetor we sell has been pre-tested by each manufacture and given 100% perfect condition stamp of approval. When considering the purchase of a new carburetor- please be advised that we cannot return any carburetor for any reason. Before installing a new carburetor- please insure that the fuel lines and gas tank have been thoroughly cleaning and flushed of all dirt and rust. Also - always replace all rubber fuel hoses and filters. It is your responsibility to guarantee the cleanliness of your fuel system. This is the only reason you will ever have a problem with a new carburetor.
If you need technical assistance concerning the tuning and adjustments of your new carburetor, Our tech support line is open 8:00am-5:00pm Mon-Fri. to assist you,
Call Toll Free: 1-800-313-3811 OR 1-604-881-7858. (Ask for Carburetor technical support).